And we're back!
Started by Josquius, December 02, 2018, 01:43:30 PM
Quote from: Tyr on August 10, 2021, 06:31:13 AMStrange installation experience.Put them both in and turn on my computer.... Nothing. The lights are on but nobody's home. No signal detected on my monitor.I take one of them out...and a bit better. It is on the initial boot screen where it tells me overclocking has failed- I switch the profile back to the old one and the computer starts up.I put the other back in and, slower than normal (it takes a while to get things setup for new ram?), it all loads up and works fine.Its exactly the same model as my pre-existing ram so very curious. Will try putting the other profile back on again, hopefully just needed some backend work to figure out what to do with 4 ram rather than 2.
Quote from: Tyr on August 23, 2021, 06:02:07 AMI tried just switching the ram speed to 3200 and leaving all other options on auto but it fails too.I note the old and new aren't actually totally identical. Ras precharge is 15-15-15-18 and single rank on 2 and 14-15-15-18 dual rank on the others.
Quote from: Tyr on August 24, 2021, 02:51:24 AMBoth should be 3200 ram, or so it says on the box. They just default to 2133 without the xmp profile turned on.
Quote from: Tyr on August 25, 2021, 03:44:23 AMSorry. Start again.Both sets of RAM, old and new, which are a very similar model are advertised on the box as 3200 but default to 2133 unless I turn on XMP.
Page created in 0.054 seconds with 19 queries.